Prevent your wind turbine from freewheeling damage by using these 0.75 ohm brake resistors to slow down the turbine when your battery is fully charged.
The other resistors on the market run dangerously hot and are complicated to install. Our resistors are designed specifically to run cooler and to be easier to install.
Our premium aluminum housed resistors are FAR SUPERIOR to the traditional round cylindrical red, pink, green, etc resistors on the market. Here's why:
- In an open air environment, with no fans*:
- Our resistors run at 130-140°C (266-284°F).
- Traditional ceramic round resistors: 200-240°C (392-464°F)
- Pre-wired for quick installation. Supplied with .162" metal ring terminals that will fit a #8-32 screw.
- High temperature wire fiberglass insulated oven wire rated for 500°C saves time for a quick install. Wire length: 13"
- Aluminum extruded housing with heat sink fins for maximum heat dissipation.
Dump load resistors can be dangerous and cause fires if not installed or maintained properly. Always mount them on a metal or concrete (non-flammable) surface, never on a wood or drywall surface. Interesting fact: The minimum temperature needed to ignite wood is 180°C or 356°F.
We recommend multiplying your wind turbine's capacity by 2 in order to get the dump load resistor capacity. For example: If you have a 450W wind turbine, 450 x 2 = 900W of required resistor capacity (or, 3 resistors).
|Charge controller dump voltage (VDC)||Power dissipation (W)|